DescriptionWavin Comfia UFHC1 Underfloor Heating Pack 1Single Zone | Low Temperature | Heat Pump Ready | 150mm Pipe Centres | Up to 100m² | Screeded FloorThe Wavin Comfia UFHC1 Underfloor Heating Pack 1 is a complete single-zone system designed specifically for low-temperature heating applications, including air and ground source heat pumps operating below 55°C flow temperature.Ideal for new builds and major renovations, this system is designed for installation within a screeded floor construction (screed not supplied) and provides reliable, even heat distribution across areas from 12m² up to 100m².Using 150mm pipe centres, UFHC1 delivers strong heat output suited to modern, well-insulated properties while operating efficiently at lower flow temperatures.Installation is carried out using a tacker system, where 16mm PE-RT pipe is stapled directly into the insulation layer. Each pack is supplied with the correctly sized manifold and actuators to match the selected floor area, along with the required 16mm PE-RT pipe coil and system components needed for installation, including isolation valves, temperature gauges, air vents and Eurocone connectors.Control is handled via a simple wired dial thermostat, allowing straightforward single-zone temperature management.Key FeaturesSingle-zone underfloor heating systemDesigned for low-temperature systems (below 55°C flow temperature)Ideal for heat pump installationsSuitable for screeded floor constructions150mm pipe centresWired dial thermostat includedSupplied with correctly sized manifold and actuators16mm PE-RT underfloor heating pipePerformance & Technical InformationHeat Output: Up to 83 W/m²Flow Temperature: Designed for systems operating below 55°CPipe Centres: 150mmFloor Type: Screeded (not supplied)Control Type: Wired dial thermostatEnergy Efficiency (ErP): NBrand: WavinHeat output guidance example: The above heat outputs are for guidance only, and calculated for systems installed in 75mm screed, with a flow temperature of 45ºC. For an accurate system specific application, contact Wavin for further information.Wavin also provides system design and heat output calculations upon proof of purchase, offering additional reassurance for installers and specifiers.Available in pack sizes from 12m² to 100m² — simply select the area that suits your project.
